BRUSH HOLDER SET COMPL. (39/40/46/47) SERVICE KIT

Features

• Complete brush holder assembly: Replaces the brush holder set used to support and guide carbon brushes.
• Parts reference match: Covers parts 39, 40, 46 and 47 as per the service diagram references.
• Improves brush seating: Helps maintain correct pressure and alignment for proper commutation.
• Model-specific compatibility: Intended for use with the Tork Craft TCAG0115 angle grinder.

Benefits

• More reliable power: Consistent brush contact helps reduce cutting-out and intermittent running.
• Reduced arcing and wear: Correct alignment can lower excessive sparking and slow commutator/brush wear.
• Cleaner servicing outcome: Ideal when cracked or loose holders make a brush replacement ineffective.

Extra Information

• Compatibility: Intended for the Tork Craft TCAG0115 angle grinder series.
• Recommended: Inspect/replace the carbon brushes at the same time if they are near wear limits.
• Check the commutator: Heavy burning, pitting or deep grooves may indicate the armature needs attention.
• Keep it clean: Carbon dust build-up can cause tracking and poor electrical contact — clean carefully during service.

Specifications

Safety

• Wear eye protection and a dust mask when working with carbon dust and internal debris.
• Disconnect power before opening the tool or fitting any spare parts.
• Ensure springs, holders and wiring are seated correctly — misalignment can cause sparking, overheating or motor failure.
• After reassembly, confirm the spindle rotates freely and the guard is correctly fitted before use.
• Perform a no-load test run in a safe area and stop immediately if you see heavy arcing, smell burning or hear abnormal rubbing.