POLISHER BEARING HOLDER FOR POL05

Features

• Genuine Tork Craft bearing holder for the POL05 polisher.
• Accurately machined bearing seat to hold the bearing square and secure.
• Matched to the original POL05 housing and shaft layout.
• Helps maintain correct alignment between motor, gears and spindle.
• Durable material suitable for workshop temperatures and loads.
• Direct replacement under the POL05-27 spare part reference.

Benefits

• Restores proper support and alignment for a key bearing in the POL05.
• Reduces vibration, noise and harshness caused by a distorted bearing seat.
• Helps bearings, gears and shafts last longer by keeping them correctly located.
• Improves overall feel and control when polishing, cutting or finishing.
• Extends the working life of the machine instead of replacing the whole tool.

Extra Information

Typical signs that a bearing holder may need replacement include visible cracking around the bearing seat, a bearing that fits loosely or at an angle, unusual play at the pad even with new bearings, or damage after a failed bearing has spun in the housing. In these situations, installing a new bearing alone will not solve the problem – the holder must also be renewed.

The POL05-27 bearing holder is designed specifically for the Tork Craft POL05 polisher, so locating shoulders, screw positions and clearances all match the original gearbox or motor layout. Using the correct holder together with genuine bearings helps restore the tight, confident feel that operators expect in busy panel shops and detailing bays.

Pro Tip

Pro Tip: When replacing the bearing and holder, clean the surrounding area thoroughly and inspect the shaft and mating components for wear or heat marks. Press the bearing into the new POL05-27 holder using the correct tools, supporting the outer race, and then assemble it into the machine without forcing or twisting. After reassembly, run the POL05 at low speed with no load – you should hear a smooth, even note and feel noticeably reduced vibration before returning the polisher to full-duty work.

Specifications

Safety

• Always unplug the polisher from the mains before opening the housing or gearbox.
• Allow the tool to cool down fully before handling internal components.
• Use appropriate tools to press bearings into and out of the holder – do not hammer directly on the bearing or holder.
• Ensure the new holder is seated correctly and all screws, clips and covers are properly tightened before testing.
• Test the POL05 under no load after reassembly and only return it to normal use once you are satisfied with the sound and feel.
• If you are unsure about mechanical repairs, have the work carried out by a qualified technician or an approved service centre.