POLISHER S/KIT SPEED CONTROL (43) FOR POL02

Features

• Genuine Tork Craft speed control module for the POL02 wool bonnet polisher.
• Replacement for the electronic speed control unit (item 43 on parts diagram).
• Matched to the original POL02 variable speed design and rating.
• Supports low to high speed range for different polishing stages.
• Helps maintain steady speed under load for consistent results.
• Built for regular use in workshops, panel shops and detailing bays.

Benefits

• Restores reliable variable speed adjustment on a tired POL02 polisher.
• Improves control over cutting, polishing and finishing stages.
• Helps reduce speed surging and erratic motor behaviour.
• Extends the useful life of the tool instead of replacing the whole machine.
• Using the correct OEM module simplifies future servicing and fault-finding.

Extra Information

Common signs that the speed control may need replacement include the polisher running only flat out or only at low speed, speed changes that are jerky or delayed, or the machine cutting out when you adjust the dial. Once cable, brushes and switch have been checked, the speed control module is often the next logical component to replace.

The POL02-SK13 speed control is designed specifically for the Tork Craft POL02 wool bonnet polisher. Using generic or incorrect electronic parts can lead to poor control, overheating or premature failure, so genuine Tork Craft spares are strongly recommended for professional and workshop environments.

Pro Tip

Pro Tip: Before removing the old speed control, take clear photos of the wiring layout and note the position of each lead. After fitting the new module, double-check every connection and cable route before closing the housing. Test the polisher with no load first and slowly sweep through the speed range to confirm smooth, even response before returning it to full-duty polishing work.

Specifications

Safety

• Always disconnect the polisher from the mains before opening the housing or touching internal wiring.
• Allow the tool to cool down fully before working near the motor and electronics.
• Ensure all connections are secure, insulated and correctly routed after fitting the new module.
• Refit all covers, guards and screws securely before testing the machine.
• If you are unsure about electrical repairs, use a qualified technician or an approved service centre.